STX Coilovers ST Suspensions SEAT Leon III / VOLKSWAGEN Golf VII / VOLKSWAGEN Golf VII 4Motion

Years: 11/12-

Maximum permitted front axle load (kg): -1080

Maximum permitted rear axle load (kg): -980

Front lowering (mm): 35-65

Rear lowering (mm): 35-65

Derived from motorsport, the STX range allows ultra-precise ride height adjustment while benefiting from a factory-set fixed damping rate. Height adjustment at the front and rear (where the vehicle allows it) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the original setup only has rear springs, the same applies with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspension kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

FOR models with a 55mm strut diameter on the front axle.

The original electronic suspension control system must be deactivated. The deactivation kit is available under reference KW 68510342.