STX Coilovers ST Suspensions OPEL Vectra C

Model years: 10/03-

Maximum permitted front axle load (Kg): -1230

Maximum permitted rear axle load (Kg): -1140

Front lowering (mm): 30-60

Rear lowering (mm): 30-60

Derived from motorsport, the STX range offers ultra-precise ride height adjustment, while benefiting from a factory-set fixed damping adjustment. Front and rear ride height adjustment (on vehicles where this is possible) is done via a dial located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for increased durability.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the original setup only has rear springs, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut legs are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any further information, please use our contact form.

Technical note to consider before ordering:

For vehicles fitted with electronically controlled suspension, make sure it is properly disconnected. A disconnection kit can be found in the KW accessory range, REF 68510253.