STX Coilovers ST Suspensions MAZDA Mazda 6

STX coilovers ST Suspensions for MAZDA Mazda 6, (GG/GY, GG1) MPS Sedan, four-wheel drive / Wagon, two-wheel drive

Years: 12/05-

Maximum permitted front axle weight (in Kg): -1135

Maximum permitted rear axle weight (in Kg): -1095

Front lowering in mm: 30-60

Rear lowering in mm: 30-60

Derived from motorsport, the STX range offers ultra-precise height adjustment while benefiting from a factory-set fixed damping rate. Front and rear height adjustment (on vehicles that allow it) is made via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in quantities sufficient to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure you fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential to lowering is required. The strut assemblies are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any further information.