STX Coilovers ST Suspensions FIAT Barchetta

Years: 05/95-

Maximum permitted front axle weight (in kg): -850

Maximum permitted rear axle weight (in kg): -700

Front lowering in mm: 30-70

Rear lowering in mm: approx. 40

Derived from motorsport, the STX range offers ultra-precise height adjustment, with a fixed damping setting pre-set at the factory. Height adjustment at the front and rear (where the vehicle allows it) is made via a dial located on the threaded body of the shock absorber. Galvanized finish plus anticorrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They install in place of the original suspension, without modification. For example, if the vehicle originally had only rear springs, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. Strut legs are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any other information, please use our contact form.

Technical note to consider before ordering:

Front height adjustable. Rear with lowering springs and sport shock absorbers.

Certain parts must be sourced from the manufacturer (FIAT part numbers: bearing support 777 59 40 + gasket 779 52 59 + washer 779 52 60).