STX Coilovers ST Suspensions BMW 7 Series

Years: 10/94-11/01

Maximum permitted front axle load (in kg): 1141-1255

Maximum permitted rear axle load (in kg): -1355

Front lowering in mm: 25-55

Rear lowering in mm: 25-65

Derived from motorsport, the STX range offers ultra-precise height adjustment along with a factory-set fixed damping rate. Height adjustment on the front and rear (where the vehicle allows it) is done via a disc located on the threaded body of the shock absorber. Hot-dip galvanized with an anti-corrosion coating for extended durability.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has springs at the rear as standard, the same applies with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential to lowering is required. The struts are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

Please use the contact form for any other information.

Technical note to consider before ordering:

ON vehicles equipped with M-Tech, only use the lowering spring kits. The lowering will be 20mm less than indicated

EXCEPT models equipped with the ride height correction system (or ride height correction adjustment required).

Installation may require wheel spacers.