STX Coilovers ST Suspensions AUDI A6 Quattro C6

Years: 05/04-

Maximum permitted front axle load (in kg): -1240

Maximum permitted rear axle load (in kg): -1205

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STX range allows ultra-precise height adjustment while benefiting from a factory-set fixed damping. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized treatment plus anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies to these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

Please feel free to contact us using the contact form for any further information.

Technical note to take into account before ordering:

ON models equipped with M-Tech, only use lowering spring kits. The lowering will be 20mm less than the value indicated

EXCEPT models equipped with ride height correction (or ride height correction adjustment required).