STX Coilovers ST Suspensions AUDI A4 B5 Avant

Years: -01/99

Maximum permitted front axle load (kg): -1080

Maximum permitted rear axle load (kg): -1070

Front lowering (mm): 40-75

Rear lowering (mm): 40-75

Derived from motorsport, the STX range offers ultra-precise ride height adjustment while benefiting from a factory-set fixed damping rate. Ride height adjustment on the front and rear (where the vehicle allows it) via a disc located on the threaded body of the shock. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has springs at the rear as original equipment, the same will apply with these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to fit original strut mounts for installation. ST Suspension kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut tubes are galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please feel free to contact us using the contact form.

Technical note to consider before ordering:

EXCEPT 4WD.

Damping adjustment is possible by disassembling the shock or by modifying the rear rod trim to access the top of the shock.