STX Coilovers ST Suspensions AUDI A3 / VOLKSWAGEN Golf V Plus / VOLKSWAGEN Golf VI

Years: 03/03-

Maximum permitted front axle load (in kg): 1036-1105

Maximum permitted rear axle load (in kg): -1005

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STX range allows ultra-precise ride height adjustment while benefiting from a factory-set fixed damping rate. Ride height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Hot-dip galvanized and anti-corrosion coated for enhanced longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if you only have original springs at the rear, the same applies to these ST Suspension kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please be sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

EXCEPT 4WD.

FOR models with 50mm diameter struts on the front axle.

For vehicles fitted with Audi Magnetic Ride, make sure it is properly disconnected. You can find in the KW accessories range REF 68510124, a disconnect kit