STX coilovers ST Suspensions AUDI A3 Cabriolet / SKODA Octavia III / VOLKSWAGEN Golf VII 4Motion

STX coilovers by ST Suspensions for AUDI A3, (8V) without electronically controlled suspension Cabriolet, all-wheel drive, Ø55mm struts, models with independent rear suspension (IRS)

Years: 03/14-

Maximum permitted front axle load (in Kg): -1100

Maximum permitted rear axle load (in Kg): -1090

Front lowering in mm: 30-55

Rear lowering in mm: 40-65

Derived from motorsport, the STX range offers ultra-precise ride height adjustment while benefiting from a factory-set fixed damping rate. Ride height adjustment on the front and rear (for vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

We remain at your disposal via the contact form for any further information.

Technical note to consider before ordering:

ON M-Tech equipped models, use only lowering spring kits. The lowering will be 20mm less than indicated

FOR models with 55mm diameter strut on the front axle.

For vehicles equipped with electronically controlled suspension, the disconnect box is required. Part number 68510370