STX Coilovers ST Suspensions AUDI A3 / AUDI TT 8N Coupé / SEAT Leon I / VOLKSWAGEN Golf IV

Years: 09/96-

Maximum permitted front axle load (in kg): -1020

Maximum permitted rear axle load (in kg): -1025

Front lowering in mm: 30-70

Rear lowering in mm: 30-70

Derived from motorsport, the STX range allows ultra-precise ride height adjustment while benefiting from a fixed damping setting set at the factory. Height adjustment at the front and rear (on vehicles that allow it) via a dial located on the threaded body of the shock absorber. Galvanized treatment plus anti-corrosion coating for increased longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the original setup has springs only at the rear, the same will apply with these ST Suspension kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For all other models, please remember to equip yourself with original strut mounts for installation. ST Suspension kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut bodies are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any other information, please contact us via the contact form.

Technical note to consider before ordering:

Installation may require wheel spacers.

For 50 mm diameter models, it is strongly recommended to replace the original sway bar to avoid any contact with the right-hand wheel shaft, using sway bar 66550008 (to be ordered separately). (91)

In case of extreme lowering, it is strongly recommended to replace the sway bar to avoid any contact with the right-hand wheel shaft. For a version without Xenon headlights, use sway bar REF. 685 50 000. For a version with Xenon headlights, use sway bar REF. 685 50 005