lowering springs kit for MERCEDES Class E

Years: 02/09-

Compatible vehicle power (kW): 135-225

Maximum permitted front axle load (kg): -1050

Maximum permitted rear axle load (kg): -1180

Possible front/rear lowering (mm): 30/30

Technical note to consider before ordering:

EXCEPT models equipped with a ride height corrector (or ride height corrector adjustment required).

EXCEPT models with air suspension.

EXCEPT models with air suspension.

The indicated lowering level may vary. Factory vehicles are fitted with spring seats of different heights on the rear axle. The maximum lowering is achieved using 5 mm rear spring seats. Lowering can vary using 5, 9, 13 or 17 mm

Note:

ST Suspensions shock absorbers and springs are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has springs at the rear from the factory, the same applies to these ST Suspensions kits. Be sure to use the original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and/or springs as applicable), unless an accessory essential for lowering is required.

Shock absorber cartridges, however, are sold individually! You will therefore need to order at least 2 to equip one axle.

WARNING: compatible power ratings are expressed in kW (kilowatts). To find the hp equivalent, convert this figure (1 kW = 1.36 hp). Online converters are also available.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please contact us using the contact form.