lowering springs kit for BMW 3 Series

Years: 01/88-04/95

Compatible vehicle power (in kW): 75-83

Maximum permitted front axle load (in kg): -790

Maximum permitted rear axle load (in kg): -1030

Possible front/rear lowering (in mm): 50/40

Technical note to consider before ordering:

EXCEPT for models equipped with a ride height corrector (or ride height corrector adjustment required).

FOR fitting on a strut with 51 mm outer diameter (check on vehicle before ordering)

FOR fitting on a strut with 51 mm outer diameter (check on vehicle before ordering)

Please note:

ST Suspensions shock absorbers and springs are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if you only have original rear springs, the same applies to these ST Suspensions kits. Remember to fit the original strut mounts. ST Suspensions kits are supplied bare (shock absorber cartridges and/or with springs as applicable), unless an accessory essential for lowering is required.

Shock absorber cartridges are sold individually, however! You will therefore need to order at least 2 to equip one axle.

CAUTION: compatible power ratings are expressed in kW (kilowatts). To find the hp equivalent, convert this figure (1 kW = 1.36 hp). Online converters are also available.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please use our contact form.