lowering springs kit for AUDI A3 / SEAT Leon III / VOLKSWAGEN Golf VII

Years: 08/12-

Compatible vehicle power (in kW): 90-110

Maximum permitted front axle weight (in kg): -945

Maximum permitted rear axle weight (in kg): -1000

Possible front/rear lowering (in mm): 40/40

Technical note to consider before ordering:

FOR models with 55mm diameter strut on the front axle.

For models with torsion beam (rigid axle)

For models with torsion beam (rigid axle)

Please note:

ST Suspensions shock absorbers and springs are supplied in quantities sufficient to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the original setup only has springs at the rear, the same will apply to these ST Suspensions kits. Remember to use the original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and/or with springs as applicable), unless an accessory essential for lowering is required.

However, shock absorber cartridges are sold individually! You will therefore need to order at least 2 to equip an axle.

IMPORTANT: compatible power ratings are expressed in kW (kilowatts). To find the hp equivalent, convert this figure (1kW = 1.36hp). Online converters are also available.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please use our contact form.