lowering springs kit for AUDI A3 / SEAT Leon III / VOLKSWAGEN Golf VII

ST Suspensions lowering springs kit for AUDI A3 (8V) 2WD Sedan (3 doors), (4 doors), Sportback (5 doors) 1.8TFSi s-tronic, 1.6TDi, 2.0TDi

Years: 08/12-

Compatible vehicle power (in kW): 77-110

Maximum permitted front axle weight (in Kg): -1060

Maximum permitted rear axle weight (in Kg): -1000

Possible front/rear lowering (in mm): 30/30

Technical note to consider before ordering:

EXCEPT all-wheel drive (4WD).

FOR models with a 55 mm diameter strut on the front axle.

FOR vehicles with an independent axle (wishbone type)

FOR vehicles with an independent axle (wishbone type)

Please note:

ST Suspensions shock absorbers and springs are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if your vehicle only has springs at the rear as original equipment, the same applies to these ST Suspensions kits. Be sure to use the original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and/or springs as applicable), unless an accessory essential for lowering is required.

Shock absorber cartridges, however, are sold individually! You will therefore need to order at least 2 to equip one axle.

WARNING: compatible power outputs are expressed in kW (kilowatts). To find the equivalent in hp, convert this figure (1 kW = 1.36 hp). Online converters are also available.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

Please feel free to contact us via the contact form for any further information.