lowering spring kit for VOLKSWAGEN Bora / Golf IV

ST Suspensions lowering spring kit for VOLKSWAGEN Bora (1J) 2-wheel drive Sedan 2.3 V5, 1.9SDi, 1.9TDi

Years: 10/98-05/05

Compatible vehicle power (in kW): 50-132

Maximum permitted front axle load (in kg): -980

Maximum permitted rear axle load (in kg): -960

Possible front/rear lowering (in mm): 50/50

Technical note to consider before ordering:

For 50 mm diameter models, it is strongly recommended to replace the original sway bar to avoid contact with the right-hand wheel shaft. Use sway bar 66550008 (to be ordered separately). (91)

With a 45 mm front lowering, it is recommended to change the sway bar. See our kit REF. 68550000 (without Xenon headlights) or 6855005 (with Xenon headlights)

Please note:

ST Suspensions shock absorbers and springs are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if you only have original rear springs, the same will apply to these ST Suspensions kits. Make sure to use the original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and/or springs as applicable), unless an accessory essential for lowering is required.

Shock absorber cartridges are sold individually! You will therefore need to order at least 2 to equip an axle.

ATTENTION: compatible power ratings are expressed in kW (kilowatts). To find the hp equivalent, convert this value (1 kW = 1.36 hp). Online converters are also available.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Please feel free to contact us using the contact form for any other information.