Coilovers STXTA ST Suspensions AUDI A1 / AUDI A1 Sportback / SEAT Ibiza V / VOLKSWAGEN Polo IX

STXTA Coilovers ST Suspensions for AUDI A1, (8X)

Years: 08/10-

Maximum permitted front axle load (in kg): 901-960

Maximum permitted rear axle load (in kg): -840

Front lowering in mm: 15-50

Rear lowering in mm: 15-50

Derived from motorsport, the STX-TA range allows ultra-precise height adjustment along with damping adjustment. Height adjustment on the front and rear (for vehicles that allow it) is made via a ring located on the threaded body of the shock absorber. Supplied with adjustable aluminum top mounts for precise camber adjustment as needed. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has rear springs as original equipment, the same applies to these ST Suspensions kits.

The only models sold with top mounts are the STXTA coilovers. For any other model, please make sure to fit original top mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut legs are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

ON M-Tech equipped models, only use the lowering spring kits. Lowering will be 20 mm less than indicated