Coilovers STXA ST Suspensions VOLKSWAGEN Passat B6 4-Motion / B6 Berline / B7 / CC 4-Motion

Years: 03/05-10/14

Maximum permitted front axle load (in kg): 1106-1180

Maximum permitted rear axle load (in kg): -1150

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STXA range allows adjustment of both height AND damping. Height adjustment at the front and rear (for vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber rod. For all those who need to fine-tune their setup for a customized "setup". Galvanized treatment + anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if you only have springs at the rear as original equipment, the same applies with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please be sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

Please use the contact form for any further information.

Technical note to consider before ordering:

FOR model with 55mm strut diameter on the front axle.

For vehicles equipped with DDC electronically controlled suspension, check that it is properly disconnected. You can find in the KW accessory range REF 68510141, a disconnection kit