Coilovers STXA ST Suspensions VOLKSWAGEN Golf VII

STXA threaded coilovers from ST Suspensions for VOLKSWAGEN Golf VII Variant, (AUV) Wagon, 2WD, models with independent rear suspension ( IRS ) Ø 50mm struts

Years: 07/13-

Maximum permitted front axle weight (in Kg): 966-1090

Maximum permitted rear axle weight (in Kg): -1050

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STXA range allows adjustment of both ride height AND damping. Height adjustment at the front and rear (on vehicles that allow it) via a ring located on the shock's threaded body. Very precise damping adjustment via a progressive knob located at the top of the shock shaft. For anyone who needs to fine-tune their settings to achieve a personalized "setup". Galvanized finish plus anti-corrosion coating for extended longevity.

ST Suspensions threaded coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Please feel free to contact us via the contact form for any other information.

Technical note to consider before ordering:

On models equipped with M-Tech, use only lowering springs. Lowering will be 20mm less than indicated

FOR models with 50mm diameter struts on the front axle.

The original electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.