Coilovers STXA ST Suspensions SEAT Toledo III

Years: 10/04-

Maximum permitted weight on front axle (in kg): 1036-1100

Maximum permitted weight on rear axle (in kg): -1150

Front lowering in mm: 25-55

Rear lowering in mm: 30-60

Derived from motorsport, the STXA range allows adjustment of both height AND damping. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber shaft. For anyone who needs to fine-tune their setup and achieve a personalized setup. Galvanized finish plus anti-corrosion coating for enhanced longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the original setup only has springs at the rear, the same will apply to these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

Please feel free to contact us via the contact form for any further information.

Technical note to consider before ordering:

FOR models with 50mm diameter strut on the front axle.