Coilovers STXA ST Suspensions SEAT Toledo III

Years: 10/04-

Maximum permitted front axle weight (in Kg): -1035

Maximum permitted rear axle weight (in Kg): -1150

Front lowering in mm: 25-55

Rear lowering in mm: 30-60

Derived from motorsport, the STXA range allows adjustment of BOTH ride height AND damping. Ride height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise damping adjustment via a progressive knob located at the top of the shock absorber rod. For anyone who needs to fine-tune their setup to achieve a personalized "setup". Galvanizing + anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if you only have springs at the rear as original equipment, the same applies with these ST Suspension kits.

The only models sold with strut mounts are STXTA coilovers. For any other model, remember to equip yourself with original strut mounts for installation. ST Suspension kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. Struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

FOR models with a 50mm diameter strut on the front axle.