Coilovers STXA ST Suspensions SEAT Leon III / VOLKSWAGEN Golf VII / VOLKSWAGEN Golf VII 4Motion

Years: 11/12-

Maximum permitted front axle weight (in Kg): -965

Maximum permitted rear axle weight (in Kg): -980

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STXA range allows adjustment of both ride height AND stiffness. Ride height adjustment at the front and rear (where the vehicle allows it) via a collar located on the threaded body of the shock absorber. Very precise stiffness adjustment via a progressive knob located at the top of the shock absorber shaft. For those who need to fine-tune their setup for a personalized configuration. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies to these ST Suspension kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to use original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any further information, please use our contact form.

Technical note to consider before ordering:

FOR models with 50 mm strut diameter on the front axle.

The original electronic suspension control system must be deactivated. The deactivation kit is available under part number KW 68510342.