Coilovers STX ST Suspensions AUDI A3 Quattro

Years: 09/03-

Maximum permitted front axle load (in Kg): -1105

Maximum permitted rear axle load (in Kg): -1160

Front lowering in mm: 25-55

Rear lowering in mm: 25-55

Derived from motorsport, the STX range allows ultra-precise ride height adjustment, while benefiting from a fixed damping setting set at the factory. Ride height adjustment on the front and rear (where the vehicle allows it) via a disc located on the threaded body of the shock absorber. Galvanized finish + anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, the same applies with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut assemblies are made of galvanized steel.

ST Suspensions is a KW brand, and products of this brand are manufactured by KW.

For any further information, please feel free to contact us using the contact form.

Technical note to consider before ordering:

ON models fitted with M-Tech, only use lowering springs. The lowering will be 20mm less than indicated

FOR models with a 55mm diameter strut on the front axle.