Coilovers STX ST Suspensions ALFA ROMEO Mi.To / FIAT Grande Punto / OPEL Corsa D / OPEL Corsa E

Years: 11/09-

Maximum permitted front axle load (kg): -1000

Maximum permitted rear axle load (kg): -850

Front lowering in mm: 25-40

Rear lowering in mm: 35-50

Derived from motorsport, the STX range offers ultra-precise height adjustment while benefiting from a factory-set fixed damping stiffness. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended service life.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as standard, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any other information, please use our contact form.

Technical note to consider before ordering:

For vehicles equipped with electronically controlled suspension, check that it is properly disconnected. A disconnection kit is available in the KW accessory range under REF 68510180