STX Coilovers ST Suspensions SEAT Leon I

Years: 11/99-

Maximum permitted front axle load (kg): -1020

Maximum permitted rear axle load (kg): -1020

Front lowering (mm): 35-65

Rear lowering (mm): 35-65

Derived from motorsport, the STX range offers ultra-precise height adjustment while benefiting from a factory-set fixed damping level. Front and rear height adjustment (on vehicles that allow it) is made via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for extended durability.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has rear springs as original equipment, the same applies to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA threaded coilovers. For any other model, please make sure to use original strut mounts for installation. ST Suspensions kits are supplied bare (shock cartridges and springs where applicable), unless an accessory essential for lowering is required. The strut legs are made of galvanized steel.

ST Suspensions is a brand of KW, and products under this brand are manufactured by KW.

For any other information, please use our contact form.

Technical note to consider before ordering:

Installation may require wheel spacers.

For models with a 50 mm diameter, it is strongly recommended to replace the original sway bar to avoid any contact with the right-hand driveshaft. Use sway bar 66550008 (sold separately). (91)

For extreme lowering, it is strongly recommended to replace the sway bar to avoid any contact with the right-hand driveshaft. If the vehicle has no Xenon headlights, use sway bar REF. 685 50 000. If it has Xenon headlights, use sway bar REF. 685 50 005.