STX Coilovers ST Suspensions AUDI S3

Years: 05/13-

Maximum permitted front axle load (in kg): -1100

Maximum permitted rear axle load (in kg): -1040

Front lowering in mm: 0-30

Rear lowering in mm: 5-30

Derived from motorsport, the STX range offers ultra-precise height adjustment, while benefiting from a factory-set fixed damping rate. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Galvanized finish plus anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They replace the original suspension without modification. For example, if the original setup has only springs at the rear, the same will apply to these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For all other models, please make sure to fit original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

For any other information, please use our contact form.

Technical note to consider before ordering:

On M-Tech equipped models, only use lowering spring kits. The lowering will be 20mm less than the value indicated

FOR models with 55mm diameter strut on the front axle.

For vehicles equipped with electronically controlled suspension, the disconnect box is required. Part number 68510370